
Emax Magnum F4 AIO FPV Full Stack Flight Controller ESC VTX - V2
Emax Magnum F4 AIO FPV Full Stack ESC VTX
The Magnum Tower System is the complete solution to building a modular racing drone without all the mess. Featuring high performance electronics need for your UAV, the Magnum Tower System revolutionizes the way Drones are designed and built.
The 6-in-1 features everything you need, the tower includes an F4 Flight Controller, 30a Bullet ESCs, 200mw VTX, FrSky Receiver, OSD and a Power Distribution Board. All of this is stacked in an easy to replace tower system in case any of the parts get damaged.
DOWNLOAD MAGNUM F4 MANUAL -->> MANUAL
6 in 1 Main Board
- Flight controller (OMNIBUSF4 Firmware)
- STM32F405 MCU
- MPU6000 accelerometer/gyro (connected via SPI)
- On-board Betaflight OSD
- On-board Buzzer
- Integrated 5V/3A BEC
- Integrated LC Filter
- Dedicated PPM/ Sbus receiver input
- On-board high-capacity 16mb black box flight log recorder
- 3 UART pads
- Addressable LED pad
VTX Board
- Frequency band:5362-5945MHz
- Channels: 48 (band/channel chart can be found in mannual)
- Transmit power:Switchable 25/200mw
- Supply voltage:4.5V-5.5V
- Antenna port :50Ω ipx ufl connector
- Antenna: 1pc lightweight 5.8g dipole 100mm whip. 1pc. SMA extension 80mm length
4 in 1 ESC and Current Sensor Board
- Continuous current 30A and 40A burst per motor
- Supply voltage 2-4S Lipo
- Silabs EFM8BB21F16G 50mhz MCU
- BLHeli_S firmware
- Supports DSHOT, MULTISHOT,ONESHOT125
- Top quality MOSFET
- 3oz high TG PCB board
- On-board current sensor
Receiver Board
- Genuine FrSky XM+ receiver
- D16 Mode
- 16 channel SBUS
- RSSI on Channel 15
Magnum F4 Package Includes:
- 1 x B-017 XT60 female connector
- 1 x Hot-shrinkable tube Φ4.5*0.2*L20mm red
- 1 x Hot-shrinkable tube Φ4.5*0.2*L20mm black
- 1 x Silicon wire 14AWG L=80mm red
- 1 x Silicon wire 14AWG L=80mm black
- 1 x Antenna adapter with SMA female connector L=80mm
- 1 x 5.8G antenna L=100mm
- 9 x Nylon nuts M3 black
- 5 x Nylon screws M3x6 black
- 5 x Nylon posts M3*5+6mm black